SacCity: VZ intersection 15: Grand Ave & Marysville Blvd

Note: General information on the Top 20 intersections is available on ArcGIS Hub Getting Around Sac GIS ‘SacCity Vision Zero‘ page. Other posts on Top 20 intersections are available at Tag: Top 20 Intersections.

I am looking more closely at the Top 20 intersections identified in the City of Sacramento Vision Zero Action Plan Update. Intersection 15 is Grand Ave & Marysville Blvd.

Design

Lanes: Grand Avenue both west and east of Marysville Blvd is four lanes (one through, one left turn, one right turn, and one opposite). Marysville Blvd south of Grand Avenue is three lanes (one through, one left turn, and one opposite). Marysville Blvd north of Grand Avenue is five lanes (two through, one left turn, and two opposite). The corners on the north side of the intersection are a high radius, a known safety hazard. Lane total is 16.

Medians: Concrete medians are present on Marysville Blvd, but not on Grand Avenue.

Crosswalks: Crosswalks are present on all intersection legs, but it is unknown if they have been upgraded from the low-visibility parallel lines.

Bicycle Facilities: Marysville Blvd south of Grand Avenue has mostly separated bikeways, installed as part of the Marysville Vision Zero Safety Project. Marysville Blvd north of Grand Avenue does not have bike facilities. Grand Avenue west of Marysville Blvd has Class 2 bike lanes, though they become advisory at intersections, and do not have green paint or protection. Grand Avenue east of Marysville Blvd does not have bike facilities.

Speed: Grand Ave is posted 30 mph. Marysville Blvd is posted 35 mph.

The city no longer has a database or map of speed limits, though it has promised an updated database for many years now. I have used an old database, sometimes checked against Google Maps Street View for speed limit signs. The speed limits have not been field checked. The county (and SACOG) have a database, but it does not include the City of Sacramento roadways.

Transit: The intersection area is served by SacRT routes 15 Del Paso Heights and 86 Grand.

Crashes

In the 2015 to 2024 period (which is used in the Vision Zero Action Plan Update), there were four severe injuries at this intersection, two involving pedestrians and two involving motor vehicles. These are mapped below (pdf).

The orange dots are severe injuries (one contains three crashes); the red dots are fatal (none). Together, these are know as KSI = killed or severe injury. ‘Other visible injury’ and ‘complaint of pain’ crashes are not shown on my map, since these are not the focus of Vision Zero, however, there are a few of these along both roadways, which you may view in the Crash Dashboard Interactive Map.

Please note that the exact crash locations may not be accurate, as police reports often do not correctly locate crashes. Also note that ‘pedestrian violation’ entry may be false, as police often blame crashes on the person walking when actual responsibility is not clear, or the pedestrian is dead and can’t counter the driver story.

map of Grand Ave & Marysville Blvd
Grand Ave & Marysville Blvd, VZAP update Top 20

The crash details, available in the Vision Zero Crash Dashboard Interactive Map, are below.

SacCity: Marysville Blvd VZ Phase 1 complete

This post updates the Marysville Blvd VZ Safety Project starts post from March 2026. The Phase 1 quick-build project is complete.

Northbound, the project starts just beyond Los Robles Blvd, and ends at Grand Avenue. Southbound, the project starts just beyond Harris Avenue, and ends just beyond Nogales Street. The focus of the project is narrowing the roadway from four lanes to two lanes with adjacent bike lanes or separated bikeways. Some bicycle facilities are just paint on the ground, while some stretches use vertical delineator (both green K-71 and white ‘wands’ with bases). A typical section is below. The bike lanes at the north and south ends are of poor quality, depending on the gutter pan with a strong linear seam to achieve minimum width. In the middle section, the quality varies but is mostly acceptable.

photo of Marysville Blvd northbound, north of Rosalind St, separated bikeway with K-71 delineators
Marysville Blvd northbound, north of Rosalind St, separated bikeway with K-71 delineators

The project uses shared bike lane/turn lane areas at Grand Avenue, below. This is not the worst design, placing bike lanes to the right of right-turning vehicles, but neither will it be comfortable for many bicyclists.

photo of Marysville Blvd northbound at Grand Ave, shared bike lane and right turn lane
Marysville Blvd northbound at Grand Ave, shared bike lane and right turn lane

Observing motor vehicle traffic on a Saturday, it appears that drivers have adjusted to the change. Though the varying treatment of the right-of-way might be confusing, it seems to be handled OK. The only issue is that a police motorcycle used the bike lane to bypass traffic, and almost hit me. I did not see anyone bicycling along Marysville, though I did see a number of bicyclists crossing Marysville at side streets.

The signal faces at Marysville Blvd and Grand Avenue were replaced. Other signals were not changed, so far as I can determine. One of the signal faces for Marysville northbound at Grand is out, probably due to mis-wiring.

SacRT bus Route 86 runs on this section of Marysville Blvd. Bus stops were marked with dashed (skip) green markings for sharing with bicyclists, below. I suspect the bus area is not long enough for bus use, but since I did not see an buses along the route today, I’m not sure. The bus only runs once per hour on Saturdays. I think the design is safe for bicyclists since it is such a clearly marked area. The only better design would be a bikeway behind (curb-side) from a bus boarding island, though with only one lane for motor vehicles, the city is very reluctant to have buses stop in traffic. I’ve got not problem with it, transit riders have no problem with it, but engineers just can’t stomach giving priority to buses.

photo of Marysville Blvd shared bus and bike area
Marysville Blvd shared bus and bike area

No improvements to sidewalks were made, not even corner curb ramps at the most critical intersection of Marysville Blvd and Grand Avenue.

This section of Marysville Blvd is characterized by:

  • moderate to poor sidewalk conditions and width
  • sidewalk cross-slopes at nearly every driveway, which is a hazard for mobility devices and many walkers
  • abandoned business building, and abandoned parcels that may have once been occupied by businesses or residences
  • an excess for driveways, most of are not in use; a number of the parcels have two or more abandoned driveways; even the City of Sacramento Hagginwood Park has an abandoned driveway

One example of a driveway that slopes across the sidewalk is below. There are dozens of locations just in this section of Marysville, to say nothing of north and south of the project. Some are active driveways for commercial buildings and residences, but probably at least one-third are abandoned, serving no purpose whatsoever except to make the walking/rolling experience less pleasant and more dangerous.

photo of 3617 Marysville Blvd, abandoned driveway with cross-sidewalk slope
3617 Marysville Blvd, abandoned driveway with cross-sidewalk slope

The project has done nothing to improve the walkability of Marysville Blvd.

The signal which seems to be most confusing to walkers and drivers is the partial signal at Los Robles Blvd on the east and Hagginwood Park on the west. It was not improved in any way. Drivers are unclear about the signal, and so are not sure whether to yield to walkers in the two crosswalks.

I will have at least one more post on Phase 2 of the project, which is not fully funded and has not started.

Photos on Flickr: Marysville-Blvd; https://www.flickr.com/photos/allisondan/albums/72177720333687456